Arduino flasher 3.3v
This explains how to:
- Easily lower the voltage of an arduino
- Use that arduino to flash a coreboot image on a GM45 Thinkpad with a SOIC16 chip
- An AVR Arduino at 5v
- An USB<->Serial adapter capable of providing enough current to power up:
- The arduino
- The flash chip
- The circuits around the flash chip
It was tested with:
- An Arduino.org "nano version 3.3"
- A Sparkfun "FTDI Basic 3v3" (Uses an FTDI FT232R)
In the Atmega328/P datasheet, the "32.3. Speed Grades" chapter describes (pages 368 and 369) the link between maximum frequency of the microcontroller and the voltage. At 3.3v, the maximum frequency is 12Mhz.
First download frser-duino:
git clone --recursive https://github.com/urjaman/frser-duino.git
Then modify the F_CPU value in main.h to be 12Mhz instead of 16Mhz: F_CPU will look like that:
#define F_CPU 16000000UL
Change it to:
#define F_CPU 12000000UL
- Flash the Arduino with frser-duino
# make ftdi # make flash-ftdi
- Connect the FTDI adapter to RX and TX of the arduino
- Connect the 3V3 of the FTDI adapter to the 5V pin of the Arduino
- Connect the GND of the FTDI adapter to the GDN of the arduino.
- Get an USB cable and don't connect it to the computer
- Connect it to the FTDI adapter
- If you use a clip (Like a SOIC-8 or SOIC16 Pomona clip), connect it to the arduino
- Connect the chip to the clip, or if you don't use a clip, the chip to the arduino
- Connect the USB cable to the computer.
- Run flashrom like that:
flashrom -p serprog:dev=/dev/ttyUSB0:115200
Research and thanks
- At 3.3V setup doesn't work with frser-duino default settings (make ftdi && make flash-ftdi)
- Thanks a lot to SwiftGeek on IRC (#libreboot on Freenode) for finding and explaning to me how to workaround it
- I still need to understand why it works when lowering the clock, it is probably related to the crystal. I need to look in the atmega328P datasheet to understand.